09.01.2021
The service of pasting the entire vehicle or its individual parts with a film is in great demand. Car owners prefer to protect the bumper, headlights, hood and other parts from getting gravel, small debris and anything that can cause damage. To make the process of gluing vinyl or polyurethane film even easier and more efficient, we have developed patterns for the car bumper and other elements.
To apply the film to individual sections of the vehicle as smoothly as possible, the master must constantly level it and adjust it to the parameters of the machine. The pattern is essentially a ready-made pattern that allows you to avoid the above actions.
Currently, there are two ways to produce such blanks. The most complex manual method of making patterns. To do this, the master will need to use a thin material like tracing paper to capture the contours of the element of the car for which the patterns are made. With the help of scissors, the workpiece is cut along the contour, then leveled and superimposed again. In general, the process is not difficult, but problems can arise if, for some reason, the master unevenly cut the workpiece or initially incorrectly made the necessary measurements. Then the production time of the patterns increases significantly.
In order to avoid such complications, a specialized software was developed that contains ready-made diagrams of individual parts of the most popular vehicle models: patterns for the car interior, hood, wings, etc.In order to get a ready-made blank, you just need to select the model, set the necessary parameters and give the command to the plotter. The difficulty may arise if you plan to make a template for an unpopular vehicle that is not in the database. Also, before cutting on the plotter, you should perform a test rolling of the film, since sometimes the device can chew it or cut it in the wrong place. As a result, the expensive material will be damaged.