02.12.2021
Procedure of actions
First of all, it is necessary to prepare the protective coating for removal. To do this, it is treated with a jet of hot air supplied, for example, with a construction hair dryer. Thanks to this, the glue that fixes the coating to the car body softens. You can understand this by the appearance of bubbles, waves and bends on the film. After that, it is necessary to carefully pick up the edge of the protective coating with a thin, but not sharp tool. Then slowly pull the film at an angle of 45 degrees to the middle. Do not forget to heat its surface as you go. If you act carefully, then the gap will not happen.
Some drivers use cheap films for pasting the car, which contain very few plasticizers. Over time, they evaporate, as a result of which the coating loses elasticity and comes off in small pieces, which makes the removal process very long and difficult. In this case, it is necessary to use a special solvent from a mixture of carboxylic acid esters, which does not harm the paintwork. Moisten a cloth (for example, a sheet) with the product, and then cover the car with it. It is recommended to wrap it with polyethylene from above. Leave the car for 10-12 hours. As a result of the chemical reaction, the film will soften and become more elastic, which will simplify its removal.
After removing the film, traces of glue often remain on the car body. Removing them manually is long and difficult, so it is most effective to use solvents. It is necessary to cover the body with a cloth soaked in the product for 10-15 minutes, and then clean off the remnants of glue. If this does not help, you can treat the surface with a grinding machine with a matting disc.
Our company also offers patterns for pasting the car body. We have options for all popular models.
First of all, it is necessary to prepare the protective coating for removal. To do this, it is treated with a jet of hot air supplied, for example, with a construction hair dryer. Thanks to this, the glue that fixes the coating to the car body softens. You can understand this by the appearance of bubbles, waves and bends on the film. After that, it is necessary to carefully pick up the edge of the protective coating with a thin, but not sharp tool. Then slowly pull the film at an angle of 45 degrees to the middle. Do not forget to heat its surface as you go. If you act carefully, then the gap will not happen.
Some drivers use cheap films for pasting the car, which contain very few plasticizers. Over time, they evaporate, as a result of which the coating loses elasticity and comes off in small pieces, which makes the removal process very long and difficult. In this case, it is necessary to use a special solvent from a mixture of carboxylic acid esters, which does not harm the paintwork. Moisten a cloth (for example, a sheet) with the product, and then cover the car with it. It is recommended to wrap it with polyethylene from above. Leave the car for 10-12 hours. As a result of the chemical reaction, the film will soften and become more elastic, which will simplify its removal.
After removing the film, traces of glue often remain on the car body. Removing them manually is long and difficult, so it is most effective to use solvents. It is necessary to cover the body with a cloth soaked in the product for 10-15 minutes, and then clean off the remnants of glue. If this does not help, you can treat the surface with a grinding machine with a matting disc.
Our company also offers patterns for pasting the car body. We have options for all popular models.